How to stop water trickling into the toilet bowl
A trickling toilet tank causes wastage of water. According to the reports of environmental protection agencies, it wastes near about 200 gallons of water per day. On the other hand, it also wastes your electricity, as with the help of electricity water enters the pipe and stays in pressure. However, a leaking toilet can create a pool on the floor. Jokes apart, mending a cracked toilet is no tough job. There can be two reasons behind the leakage. Whether the tank is overflowing or there is a crack inside the tank. However, if you are here for tips regarding how to stop water trickling into the toilet bowl, then keep reading this blog.
Mentionable steps to stop water trickling
- Observe the water level after removing the tank cover. Now check if the water level is at the level of the overflow tube or not. If it is, then it may drain the water into the tube as the level is way too high. You need to adjust the float and reset the level.
- Next, you need to turn off the water valve that is under the toilet. After that flush the water to empty the tank. Now if your float is attached to the tube, move the stop guide down the overflow tube.
- In the next step, with a pair of pliers rotate the rod. Rotate it until the middle-bend is moving upward keeping the ball deeper in the tank. If you find no bend on the rod, unscrew the ball and make it longer. However, for better leaking tap hacks, you can contact experienced plumbers anytime.
- After that, to check the water level, turn on the valve after a thorough adjustment. Hence, to optimize the level you will need to repeat the whole procedure. In the end, when the water level is an inch below the overflow tube, shut off the valve.
- Next, if you want to check if the water is draining into the bowl you can use a simple technique. Just place some blue disinfectant in the water of the toilet tank and wait for hours. In the end, if you found the bowl water is blue, then the flapper is definitely leaking.
- Another step is to check if the chain holding the flapper is long or not. Short length chains don’t allow the flapper to place into the valve aptly. Therefore, you can replace the chain with a longer one or you can also lengthen it. On the other hand, for more complex issues it is better to consult experts for more leaking tap hacks.
- In the end, if the water is still trickling replace your flapper immediately. First of all, to drain the tank completely, turn off the water valve. And then use a new flapper and connect it to the chain.
To conclude, if you follow the above tips regarding how to stop water trickling into toilet bowl you can easily handle toilet hazards.